Cone Crusher Bucket Working Procedure

Why should I choose the Auger Torque Cone Crusher Bucket?

The Cone Crusher Bucket provides a simple, efficient, and cost-effective way to reprocess and/or recycle small volume construction rubble and debris, into usable aggregate/hardcore.

Whether it’s general clay construction brick, light concrete walling blocks, hollow concrete ‘breeze blocks’, concrete pavers, asphalt and more, the Cone Crusher is highly effective at crushing to an output produced material size of around 40-70mm. Ideal for use in applications including: foundation laying, track and yard surfacing, landscaping, roadways or using as a base layer below poured concrete or filling a disposal skip most efficiently.

The Auger Torque Cone Crusher Bucket ensures you:

• Save on transport costs of removing onsite waste.
• Save on material costs of hardcore imported to site.
• Minimise site traffic, delays and hassle.

How do I use the Cone Crusher Bucket?

Excavator Operation:

• Move the Cone Crusher using the excavator boom so the Cone can be seen from the cab and ensure the cone is able to rotate both clockwise and anti-clockwise.
• Position the excavator close to the pile of material to be repurposed.
• Reach the excavator arm out past the pile of material to allow the scooping motion to occur as the cone crusher gets closer to the excavator.
• Scoop the material into the Cone Crusher drum by moving the parent machine boom in an arc until the Cone Crusher is near to vertical.
• Move the excavator boom to the area designated for the repurposed material. Rotate the cone using the auxiliary hydraulic circuit on the parent machine to crush the material. If material becomes stuck in the drum, rotate in the reverse direction until the blockage has been cleared.

Skidsteer Operation:

• Move the Cone Crusher using the Skid Steer arm so the Cone can be seen from the cab and ensure the cone is able to rotate both clockwise and anti-clockwise.
• Position the Skid Steer close to the pile of material to be repurposed. Position the crusher so the scoop section is parallel with the ground.
• Drive the Skid Steer towards the pile of material to be repurposed.
• As the scoop engages with the material move the Skid Steer arm in an arc to scoop material until the cone crusher is in a vertical orientation.
• Move the Skid Steer to the area designated for the repurposed material. Rotate the cone using the auxiliary hydraulic circuit on the parent machine to crush the material. If material becomes stuck in the drum, rotate in the reverse direction until the blockage has been cleared